Unclip any hoses on your Dirt Devil to access all the inlets and outlets.. Once you’ve got rid of the worst of the dust, follow up with a microfibre cloth (you can make this slightly damp but not wet) to remove the rest.. Never use a wet or damp cloth anywhere near the vacuum’s motor or power cord, even when the vacuum is switched off.. Summary.
You should also give the floor a quick vacuum before you start to get rid of loose dirt.. Once you’ve made the solution, add a small amount to a clean, white cloth and start using it to gently work the affected carpet fibres.Start from the outside and work inwards to prevent the stain from spreading further.
We don’t recommend spraying the mixture on the carpet directly, as you don’t want to oversaturate it..When you’ve covered the whole area, let the washing up liquid sit in the carpet for 3-5 minutes, before blotting it up with a different dry cloth (make sure it’s white).Always blot a carpet rather than rub to prevent damage.. To get rid of any remaining solution and dirt, give the area a rinse with cold water and blot it dry again with a different cloth.
Then allow the area to fully air dry before covering it..Finally, when the patch of carpet is completely dry, give it another vacuum..
You can also use a commercial carpet cleaning product for this method.
These are more expensive than using washing up liquid though – and.The Vax Blade 4 doesn’t have anti-hair technology, so it’s normal for long fibres to get caught around the brush bar.
The brush bar can also get clogged with dirt and other debris over time..Unfortunately, tangles and clogging can cause your Vax to perform worse than it should..
This is because wrapped hair prevents the brush fibres from agitating the carpet, which worsens carpet pickup.Severe clogging can even cause the vacuum’s brush bar to stop turning.. For these reasons, it’s important to maintain.